Engine (xHD5) Removal from cabinet
Engine Removal from base plate
Removing the xHD5
Engine from the Plate
1) Remove the 2 screws
(a), and 4 screws (b).
2) Carefully lift the
engine from the base
plate.
3) Add a new cushion
behind the lens.
After Replacing Engine
Copy Engine Data to DM
Refer to data transfer on page 24.
Note: The Engine has no individual
service parts available. Attempting
to disassemble the Engine may void
the warranty.
NOTE:
After Engine replacement, verify the foam gasket around the lens is properly positioned and that it does not block
the light path. The side portholes of the cabinet can be used for visual confirmation.
MODEL: WD-52631 / WD-57731 / WD-65731
Optical Engine Removal
Page 11
xHD5 Engine Removal Procedure
1) Remove 2 locking screws (b) and
ground screw (c).
2) Loosen one adjust screw (a). Less
adjustment will be required when the
Engine is installed.
3) Disconnect all leads to the Engine,
Lamp Box and Ballast.
4) Carefully slide the Engine, with the
bottom plate from the cabinet.