Winterization & Storage; Removing Boat From Water; Prior To Storage; Engine, Systems & Components - Glastron Boats User Manual

WINTERIZATION & STORAGE
This section of your owner's manual will assist you in
preparing your boat for prolonged storage. When cold
weather has arrived, or a change in your boats usage
requires extended storage, we suggest you follow the
guidelines contained within this section. For areas that do
not require seasonal storage, Glastron Boats recommends
a thorough annual inspection.
IMPORTANT: Consult your engine manual for specific
instructions covering winterization of the engine. For rec-
ommended cleaning solutions and procedures referenced,
see Section IV. Maintenance of your owner's manual.
REMOVING BOAT FROM WATER
If you do not store your boat on a
sary to lift your boat out of the water. Consult with your
dealer or marina operator when deciding how to remove
your boat. Your boat has structural components designed
to support the boat when it is being lifted. Your dealer or
marina operator should have the knowledge and equip-
ment to safely lift your boat.
Prior to lifing your boat, be sure to remove all water from
the bilge and drain all water and waste tanks. Consult your
dealer or marina operator for the proper cradle to support
your boat while it is out of the water.

PRIOR TO STORAGE

Hull
1. Scrape off any barnacles or crusted marine growth.
2. Scrub the hull thoroughly to remove marine growth
and scum.
trailer, it may be neces-
6.1
3. Inspect the underwater gear and propellers for exces-
sive wear or damage.
4. Remove the hull drain plug and store in a safe place.
Deck
1. Wash the deck, superstructure and cockpit.
2. Clean all deck hardware (i.e. cleats, rails, instruments,
etc.) and apply a coat of metal polish or wax.
3. Clean the indoor/outdoor carpet.
ENGINE, SYSTEMS & COMPONENTS
1. Drain the engine block, heat exchangers and mani-
folds. (This may vary by engine model.)
2. Drain the outdrive and change lubricant. (Your Glastron
dealer will perform No. 1 and No. 2 for a moderate fee.)
In regions where temperatures fall below
IMPORTANT:
freezing, all engine plugs must be removed before storing
your boat for the winter. Failure to do so will seriously dam-
age the engine. Freeze damage is not covered by the
Glastron Warranty. Make sure your boat's engine is slightly
bow up during the extended storage period.
Fuel System
Fill the fuel tank completely, or empty completely. Either
method will minimize condensation. You may want to add a
gasoline stabilizer solution to the fuel, if the tank is to
remain full. Follow the product manufacturer's recommend-
ed procedure.
6