Table of Contents
Advertisement
Switch on the headlamps and adjust the lamps, if necessary, until the
centre of each circle of light coincides with the centre of its respective cross.
If adjustment is necessary, proceed as follows :
Withdraw the front rim as shown on Fig. 41.
dust-excluding rubber.
which can be adjusted to align the reflector correctly.
correct alignment has been obtained, replace the rubber and rim.
It is advisable to start adjustment with each screw screwed out half-way ;
this will ensure correct fitting of the rim when assembled.
1. Vertical adjusting screw.
2.
Dust excluding rubber.
Parking Lamps (Front) and Direction Indicator Flashing Lamps
(front and rear)
To remove bulb, peel back the rubber ring and remove rim, then the bulb
can be withdrawn. When replacing rim, first slip the edge over the two
small lugs, then peel back rubber as rim is fitted. Ensure that the rubber
is located correctly over the rim edge, otherwise vibration may cause the
rim to become detached.
Tail and Stop Lamps
To gain access to the bulb, remove the cover, which is secured by two
screws.
Number Plate Lamp
To gain access to the bulb, remove the securing screw and withdraw
the cover.
ELECTRICAL SYSTEM
This will reveal three screws (see Fig. 42),
42.
Fig.
Adjusting headlamp alignment.
3.
Front rim.
4.
Horizontal adjusting screws.
4 7
Remove the
When the
SPORTS CAR
Advertisement
Table of Contents
