Table of Contents
Advertisement
You are able to preset alarms before the actual dive. The user programmable
alarms can be set for maximum depth, dive time and time. The alarms activate
when:
•
The preset maximum depth is reached
- continuous beep series for 24 seconds or until any button is
pressed.
- the maximum depth blinks as long as the present depth value
exceeds the adjusted value.
•
The preset dive time is reached
- continuous beep series for 24 seconds or until any button is
pressed.
- the dive time blinks for one minute, if no button is pressed.
•
The preset alarm time is reached
- the current time is shown.
- continuous beep series for 24 seconds or until any button is
pressed.
- the current time blinks for one minute, if no button is pressed.
OXYGEN ALARMS IN NITROX MODE
Three double beeps and the backlight activated for 5 seconds occur, when:
•
the OLF bar graph reaches 80%. The segments exceeding the 80%
limit start to blink (Fig. 3.24.)
•
the OLF bar graph reaches 100%.
The blinking of the segments exceeding 80% will stop, when the OLF is not
loading anymore. At that point the PO
Continuous beeps for 3 minutes and the backlight activated for 5 seconds
occur, when:
•
the set oxygen partial pressure limit is exceeded. The maximum depth
is replaced with a current blinking PO
ascend above the PO
NOTE! When the backlight is turned OFF, it does not illuminate when an
alarm is activated.
36
is less than 0.5 bar.
2
depth limit (Fig. 3.24.).
2
value. You should immediately
2
Advertisement
Table of Contents
