Table of Contents
Advertisement
Heating resistors: Removal - Refitting
a Partially lift the floor carpet to access the strut bolts.
a Make a mark between the strut and the panel weld-
ed on to the tunnel to ensure correct geometry when
refitting.
a Remove:
- the upper nuts (4) from the strut,
- the lower bolts (5) from the strut,
- the stay.
HEATING
II - REMOVAL OPERATION
108102
a Disconnect the heating resistor connector (6) in the
direction of the arrow.
a Remove:
- the heating resistor bolts (7) ,
- the heating resistor.
REFITTING
a Proceed in the reverse order to removal.
a Torque tighten:
- the lower bolts of the strut (21 N.m),
- the upper nuts of the strut (21 N.m).
a Check that the floor carpet reaches under the accel-
erator pedal end-stop.
a Unlock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbags and pre-
tensioners).
61A-27
61A
128047
Advertisement
Table of Contents
