Using The Wall-Mounted Door Control - Anaheim Automation Security+ 3850AD Owner's Manual

Using the Wall-Mounted Door Control

THE SMART CONTROL PANEL
Press the push bar
to open or close the
Motion Sensing
door. Press again to
reverse the door
Prog <Learn>
during the closing
cycle or to stop the
door while it's opening.
This door control
contains a motion
sensing detector that
will automatically turn
Degrees (F/C)
on the light when it
detects a person
entering the garage.
Light feature
Press the Light button to turn the opener light on
or off. It will not control the opener lights when the
LIGHT
door is in motion. If you turn it on and then
activate the opener, the light will remain on for 4-1/2
minutes. Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes
as follows: Press and hold the Lock button until the light
blinks (about 10 seconds). A single blink indicates that the
timer is reset to 1-1/2 minutes. Repeat the procedure and
the light will blink twice, resetting the timer to 2-1/2
minutes. Repeat again for a 3-1/2 minute interval, etc., up
to a maximum of four blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor. See
Automatic Light Feature, below.
Motion Sensing (Automatic Light Feature):
The opener light will turn on automatically when a
person enters the garage. When a person walks
in front of the door control, the light will come on
for five minutes, then shut off. This feature works by
detecting body heat.
To disable this feature, push the motion sensing button on
the side of the door control.
We recommend that you disable the motion sensor when
using the opener lights as working lights. Otherwise, they
will turn off automatically if you are working beyond the
sensors range.
Lock feature
Designed to prevent operation of the door from
LOCK hand-held remote controls. However, the door will
open and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
The Smart Control Panel
message: "LOCK MODE REMOTE CONTROL LOCKED
OUT PRESS LOCK BUTTON TO ENABLE REMOTE."
To turn off, press and hold the Lock button again for
2 seconds. The Lock feature will also turn off whenever the
"learn" button on the motor unit panel is activated.
®
On/Off
Hour
Minute
L I G H
Language
L O C K
Lock Button
®
will display the following
(PROG) Learn Feature
The door control is equipped with a PROG <LEARN>
button to assist in learning remote controls to the unit.
Press the PROG <LEARN> button once to initiate LEARN
Push
mode and the display will show 'Learn Remote Control -
Bar
Press Learn Button Again to Confirm'. Press the PROG
<LEARN> button a second time and the display will show
'Learn Mode - Press Remote Control Button to Learn
Remote.' Press the button of the remote control to be
learned and the worklight will blink to confirm the remote
control has been learned.
T
Light
Button
H M
(LANG) Language Feature
Press this side button to toggle between the three
languages - English, French and Spanish.
Degrees F/C Feature
Press this side button to toggle the temperature
units between Fahrenheit and Celsius.
Display Contrast Adjustment
Press and hold the light button then push the hour button
to increase the contrast or the minute button to decrease
the contrast.
27
Hour & Minute Feature
Press or hold either of these side buttons to
increment the hour or minute displayed on
the LCD display.