Anaheim Automation Security+ 3850AD Owner's Manual page 17

INSTALLING THE BRACKETS
Be sure power to the opener is disconnected. Install and
align the brackets so the sensors will face each other
across the garage door, with the beam no higher than
6" (15 cm) above the floor. They may be installed in one of
three ways, as follows.
Garage door track installation (preferred):
• Slip the curved arms over the rounded edge of each door
track, with the curved arms facing the door. Snap into
place against the side of the track. It should lie flush, with
the lip hugging the back edge of the track (Figure 1).
If your door track will not support the bracket securely, wall
installation is recommended.
Wall installation (Figures 2 & 3):
• Place the bracket against the wall with curved arms
facing the door. Be sure there is enough clearance for
the sensor beam to be unobstructed.
• If additional depth is needed, an extension bracket
(see Accessories) or wood blocks can be used.
• Use bracket mounting holes as a template to locate and
drill (2) 3/16" diameter pilot holes on the wall at each side
of the door, no higher than 6" (15 cm) above the floor.
• Attach brackets to wall with lag screws (not provided).
• If using extension brackets or wood blocks, adjust right
and left assemblies to the same distance out from the
mounting surface. Make sure all door hardware
obstructions are cleared.
Floor installation (Figure 4):
• Use wood blocks or extension brackets (see Accessories)
to elevate sensor brackets so the lenses will be no higher
than 6" (15 cm) above the floor.
• Carefully measure and place right and left assemblies at
the same distance out from the wall. Be sure all door
hardware obstructions are cleared.
• Fasten to the floor with concrete anchors as shown.
HARDWARE SHOWN ACTUAL SIZE
Carriage Bolt
1/4"-20x1/2"
Wing Nut Staples
1/4"-20
Figure 1
DOOR TRACK MOUNT (RIGHT SIDE)
Door
Track
Lip
Safety
Reversing
Sensor
Bracket
Figure 2
WALL MOUNT (RIGHT SIDE)
Figure 3
WALL MOUNT (RIGHT SIDE)
(Provided with
Extension
Bracket)
Figure 4
FLOOR MOUNT (RIGHT SIDE)
17
Indicator
Light
Lens
Fasten Wood Block to Wall with
Lag Screws (Not Provided)
Safety
Indicator
Reversing
Light
Sensor
Bracket
Lag Screws
(Not Provided)
Lens
Extension
Bracket
(See Accessories)
(Provided with
Extension Bracket)
Safety
Reversing
Sensor
Bracket
Indicator
Light
Lens
Attach with
Concrete Anchors
(Not Provided)
Lens
Indicator
Light
Safety
Reversing
Sensor
Bracket