Advertisement
LX Gas
Conversion
L.P.
install
or
adjust your gas
range.
Pressue Regulator:
Use a wrench to
unscrew the cap
the top by turning counter-
clockwise.
Turn the cap over so the hole
end is up. Replace the cap and gasket
on the regulator. DO NOT REMOVE THE
sliding the air shutter to close or open the
shutter as needed.
See Fanel C. Step 15
for electrical
ignition systems or Step 16A
for standing pilot systems.
Cc&top
burners with standing pilots
require adjustment of pilot flame to W
high. The adjustment control is located
on the manifold
pipe
or at pilot flame
base depending
on the model.
-
Oven Burner: Remove oven
racks and lower wnel
from
Oven Themmtat:
Remove
hsmostot
knob, pulling
straight off. Use a small screwdriver
to
rotate the key to L.P Replace thermostat
knob.
E
After all the burners have been
W c0nertedtoLP.gasusageand
gas line is connected,
check fcx leaks Use
a brush and liquid detergent
to test all
gas connections
for leaks Bubbles around
connectIons
will lndlcate
a leak lf a leak
appears, shut off gas vatve controls and
wrench tighten annectlons
Then check
connections
again
NEVER lESl FOR GAS
lEAKSWlTHAMKCHOROTHERFiAME.
oven bottom. Turn the orif&
hood down
until snug against pin. DO NOT
OVERTIGHTEN. The burner flame should
be Yz" long when air shutter is correctly
adjusted. The air shutter slides to close or
open the shutter as needed.
See Panel
C, Step 18 for electronic
ignition systems.
or Step 20A for standing pilot systems
Replace oven bottom and racks.
ROPER
Benton Hartxw. Mchigan 49022
Printed in U.S.A.
Fwl No. 7blclsm/43
15462
Advertisement
