Axle Lock (Tru-Lok ) - Rubicon Models - Jeep Wrangler 2010 Owner's Manual

342 STARTING AND OPERATING
AXLE LOCK (TRU–LOK ) — RUBICON MODELS
The AXLE LOCK switch is located on the lower switch
bank (below the climate controls).
Axle Lock Switch
This feature will only activate when the following con-
ditions are met:
• Key in ignition, vehicle in 4L (Low) range.
• Vehicle speed should be 10 mph (16 km/h) or less.
To activate the system, press the bottom of the AXLE
LOCK switch once to lock the rear axle only (the "Rear
Axle Lock Indicator Light" will illuminate), press the
bottom of the switch again to lock the front axle (the
"Front Axle Lock Indicator Light" will illuminate). When
the rear axle is locked, pressing the switch again will lock
or unlock the front axle.
NOTE: The indicator lights will flash until the axles are
fully locked or unlocked.
To unlock the axles, press the top of the AXLE LOCK
switch.
Axle lock will disengage if the vehicle is taken out of 4L
(Low) range, or the ignition switch is turned to the OFF
position.