Installing On A Desk Or Table - GE 30234 User Manual

Getting started

Installing on a desk or table

1. Choose an area near a
telephone modular jack
(RJ11C), and place your
telephone on a level
surface, such as a desktop
or tabletop (for wall
mounting, see instructions
on page 7).
2. Plug one end of the
handset coiled cord into
the bottom of the handset
(near the mouthpiece)
and the other end of the cord into the handset jack (on the left side of the
base), then place the handset onto the base cradle.
3. Plug one end of the telephone line cord into the LINE jack at the top of the
base and the other end into a modular jack. Please Note: If you have DSL
high speed Internet service, a DSL filter is required (not included). Contact
your DSL service provider for more information about DSL filters.
4. If you have another device (e.g. an additional telephone or data modem)
that needs to be connected to the telephone line, please connect it to the
DATA jack at the top of the base.
CAUTION: To reduce risk of personal injury, fire, or damage, use only the
power adapter provided with this product. This power adapter is
intended to be correctly oriented in a vertical or floor mount position.
5. Plug the power adapter into an electrical outlet and into the jack engraved
"9V DC" at the top of the base. Do not use an electrical outlet controlled by
a wall switch.
6. You can flip open the kick-stands on the bottom of the base for a better
viewing angle when placed on a desktop.
7. Make sure the rotating handset tab shown on page 3 is rotated to the
DESK position.
8. Adjust the VOLUME buttons (
the RINGER VOLUME switch to the desired setting: HI, LOW or OFF. You
can also adjust the pitch of the ringer by setting the RINGER PITCH switch
(HIGH/LOW).
/ ) to the desired listening level. Adjust
6