Table of Contents
Advertisement
Caller ID
Caller ID display messages
Display
BLOCKED CALL
CALL WAITING
LOW
NO CALLS
START/END
UNKNOWN
CALLER
Store caller ID record into memory
NOTE: Be sure to format the CID entries correctly before storing them. Stored entries
can be replaced but not edited.
1. Press CID (
telephone is not in use.
2. Press STORE and the screen shows LOCATION?
3. Use the dial key pad to enter a memory location (0-9) or press one of the
Programmable Emergency Call Buttons to store the number in that
memory location.
4. Press STORE three times to save the record. The screen shows OK to
confirm.
NOTE: The system cannot store any caller ID records that contain nonnumerical
information. The screen shows UNABLE TO STORE when you are trying to save them
into the memory.
To replace a stored caller ID record in memory
Repeat step 1 to step 4 in Store caller ID record into memory above.
Status
The caller of the incoming call is registered as Private
Number and the caller ID information is withheld.
A second incoming call is waiting on the line.
ON steadily when battery power level is low; flashing
when no batteries are installed.
The caller ID memory is empty.
You are at the beginning or the end of the caller ID
log.
The incoming call does not have caller ID service or
your area does not support this service. If UNKNOWN
CALLER appears along with a calling number, the
name information for that number was not available.
/
) to scroll to the desired caller ID record when the
16
Advertisement
Table of Contents
