Dodge 2010 Avenger Owner's Manual page 122

122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
• After training a HomeLink channel, if the garage door
does not operate with HomeLink and the garage door
opener was manufactured after 1995, the garage door
opener may have a rolling code. If so, proceed to Step 5
"Programming A Rolling Code System."
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to Step 5 "Pro-
gramming A Rolling Code System."
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor. It is
NOT the button normally used to open and close the
door.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button