Johnson Controls TM9V060B12MP11 Quick Reference Manual page 2

MOST COMMON INSTALLATION CONFIGURATIONS (MORE OPTIONS AVAILABLE
MULTI-POSITION CONFIGURATION INFORMATION:
Ensure that all PVC venting has at least 1/4" per foot slope towards the furnace.
Furnace is multi-position and may be installed in any of the configurations shown.
The furnace condensate pan is self priming and contains an internal trap.
Do not install an external condensate trap
When drain hose routing changes are required (shown in red), be sure to cap
all unused openings.
If rerouting hoses - excess length should be cut off so that no sagging loops will
collect and hold condensate, which will cause the furnace to not operate.
Rain
Gutter
Hose
Pressure
Switch
Hose
Condensate
Drain Hose
AIRFLOW
UPFLOW
4
For downflow applications, the gas
valve must be rotated upwards.
In upflow and downflow installation - Condensate drain hose may go out either side.
.
1
Move rain
gutter hose
to this position.
2
DOWNFLOW
Move condensate drain
hose to this position.
5
Move pressure switch
3
Move rain gutter hose
hose to this position.
to this position.
NOTE: May require the
longer hose that is provided
with wider cabinets.
WITH INDUCER ROTATION, WHICH IS COVERED IN THE INSTALLATION MANUAL)
1
Move rain gutter hose
to this position.
HORIZONTAL LEFT
1
Move pressure switch
hose to this position.
2
Change condensate drain
connection to the 90° fitting provided.
HORIZONTAL RIGHT
2
Move pressure switch
hose to this position.
NOTE: May require the
longer hose that is
provided with wider
cabinets.
AIRFLOW
3 Change condensate drain
connection to the 90° fitting provided.
4
Move condensate drain hose to this position.
5
Move rain gutter hose to this position
NOTE: May require hose extension that
is provided with wider cabinets.
3
Move rain gutter hose
to this position.
4
Move condensate drain
hose to this position.
AIRFLOW