Ford Ranger 1998 Workshop Manual page 8

1998 Ranger Workshop Manual
50. Remove the LH valve cover and gasket.
51. CAUTION: Identify the location of each rocker arm and push rod. Each rocker arm and push rod is to be installed in the original location to prevent premature wear.
Remove the rocker arms and the push rods.
52. Remove the lower intake manifold, gasket and seals.
Installation
1. NOTE: Apply a drop of silicone gasket and sealant at the four cylinder block to cylinder head seams. Use Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford
specification WSE-M4G323-A6.
Install the sealant and the intake manifold gaskets and seals.
2. Install the lower intake manifold.
3. NOTE: Apply clean Super Premium SAE 5W30 Motor Oil XO-5W30-QSP or equivalent meeting Ford specification WSE-M2C153-G to the rocker arms (6564) and push rods (6565).
Install the LH push rods and the rocker arms in their correct positions.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWL/~MUS~LEN/21...
16
11/21/2009