Jasc,D1; Table 8-2 General Commands - Geneq SXBlue GPS Reference Manual

Table 8-2 General Commands

Message
$JASC,Dx
$JAIR
$JASC,VIRTUAL
$JALT
$JLIMIT
$JAPP
$JBAUD
$JCONN
$JDIFF
$JK
$JPOS
$JQUERY,GUIDE
$JRESET
$JSAVE
$JSHOW
$JT
The following subsections provide detailed information relating to the use of each
command.
Note - Please ensure that you save any changes that you wish to survive beyond
the current power-up by using the $JSAVE command and wait for the
Complete' response.

8.2.1 $JASC,D1

This command allows you to adjust the output of the RD1 diagnostic information
message from the SXBlue GPS receiver.
This command has the following structure:
Currently, only the RD1 message is defined, with x = 1. The message status variable 'r'
may be one of the following values:
SXBlue GPS Reference Manual
Command to turn on diagnostic information.
This is a command to place the receiver into 'AIR' mode where the receiver
will respond better to the high dynamics associated with airborne
applications.
This command is used to output RTCM data fed into the other port, through
the current port
This command is used to set the altitude aiding mode of the GPS inside the
SXBlue GPS
This command is used to set the threshold of estimated horizontal
performance.
This command is used to query the current applications and also choose
the current application.
Baud rate change command for the SXBlue GPS.
Virtual circuit command used to interface to communicate with the menu
system microprocessor.
This command is used to set the differential mode.
This command is used to subscribe certain features of use of the SXBlue
GPS.
This command is used to provide the SXBlue GPS with a seed position to
acquire a SBAS signal more quickly upon start-up. This is not normally
needed.
This command is used to poll the SXBlue GPS for its opinion on whether or
not it is providing suitable accuracy after the both SBAS and GPS have
been acquired (up to 5 min)
This command is used to reset the configuration of the SXBlue GPS.
This command is used to save the configuration of the SXBlue GPS.
This command is used to query the SXBlue GPS receiver for its
configuration.
This command is used to poll the SXBlue GPS for its receiver type
$JASC,D1,r[,OTHER]<CR><LF>
Description
'$> Save
39