Cadillac CTS 2004 Manual page 84

Radio Tune: You can change the current radio station
by saying "radio tune" and the frequency of the radio
station. For example, if you say "radio tune ninety
four point seven," the station will switch to 94.7 FM. If
you are changing the station for the AM band, say "radio
tune ten seventy" for 1070 instead of "one zero seven
zero." If the station frequency has two or three
zeros, such as 600 or 1000 AM, say "radio tune
six hundred" or "radio tune one thousand." The
exception is a station frequency that includes a zero
between other numbers. In this case, say "oh" instead of
zero as in "radio tune one oh seven point nine" for
frequency 107.9 FM. This feature does not work
with XM™.
Seek Up/Down: These commands instruct the system
to seek up or down to the next or previous strongest
radio station frequency and stay there.
Scan Up/Down: These commands instruct the system
to preview the strongest radio station frequencies
either forward or backward. The system will go to the
next station, play for a few seconds, then go to the
next station.
To stop the scanning feature, say "Scan" again.
Preset X: This command instructs the system to
change the current radio station to one of the saved
preset stations on the currently active radio screen
(AM, FM1, FM2, XM1 or XM2).
4-6
To use this command, you must know the number of
the preset you wish to hear. For example, if you want to
hear the station saved to preset three, say "preset
three." If you want to hear the station saved to preset
three on a different band, you must change the
band first. See "Band Selection Commands" listed
previously.
CD Commands
The following list of verbal commands is used with the
single CD player and the six-disc CD changer. Most
of these commands can also be executed manually
using the multi-function buttons available on the
CD screen. For more information, see Navigation Audio
System on page 3-2 .
CD Player: This command instructs the system to
display the single CD player screen. If a music CD is
loaded, it will begin playing.
CD Changer: This command instructs the system to
display the CD changer screen.
Pause: This command instructs the system to stop
playing a CD. The system will remember the exact
location on the CD so that when playback resumes, it
will begin there.
Play: This command instructs the system to resume
playing a CD after the system has been paused.