Panasonic KX-UDS124 Installation Manual page 4

1 For Your Safety
•
The SIP-CS must only be installed and serviced by qualified service personnel. The SIP-CS should be
used as-is from the time of purchase; it should not be disassembled or modified. Disassembly or
modification can cause a fire, electric shock, or damage to the SIP-CS.
•
Make sure that the wall that the SIP-CS will be attached to is strong enough to support the SIP-CS (approx.
290 g). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers) included with the SIP-CS.
•
When the SIP-CS is no longer in use, make sure to detach it from the wall.
•
Disconnect the SIP-CS from the AC outlet, disconnect the LAN cable, and contact the dealer if:
–
The AC adaptor cord or AC plug becomes damaged or frayed.
–
The SIP-CS is exposed to rain, water, or any other liquid.
–
The SIP-CS is dropped or damaged.
–
Internal components are exposed due to damage.
–
The SIP-CS does not operate properly.
–
Performance deteriorates.
•
Disconnect the SIP-CS from the AC outlet and disconnect the LAN cable if the SIP-CS emits smoke, an
abnormal smell, or makes unusual noise. These conditions can cause fire or electric shock. Confirm that
smoke has stopped and contact an authorised service centre.
•
Clean the AC plug periodically with a soft, dry cloth to remove dust and other debris.
•
If using an AC adaptor, use only the optional AC adaptor KX-A239CE (PQLV206CE), KX-A239UK
(PQLV206E), KX-A239BX (PQLV206CE), KX-A239EJ (PQLV206E), or KX-A239AL (PQLV206AL).
•
If damage to the SIP-CS exposes any internal parts, immediately disconnect the cable or cord. If the power
is supplied from the network to the SIP-CS (Power-over-Ethernet), disconnect the Ethernet cables.
Otherwise, disconnect the AC adaptor cord. Then return the SIP-CS to a service centre.
•
The SIP-CS should only be connected to a power supply of the type shown on the label on the SIP-CS.
•
Completely insert the AC adaptor/power plug into the AC outlet. Failure to do so may cause electric shock
and/or excessive heat resulting in a fire.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Do not bundle cables that are connected to the SIP-CS with the AC power cords of machines located
nearby.
•
To prevent malfunction, deformity, overheating, rust, and discolouration, do not install or place equipment
in the following types of locations:
–
Locations where air ventilation is poor.
–
Locations that may be exposed to sulphurous gas, such as near hot springs.
–
Near devices that emit heat, such as heaters.
–
Near devices that emit electromagnetic noise, such as radios or televisions.
–
Near devices that emit high-frequency noise, such as sewing machines or welders.
•
The SIP-CS and the cables should never be placed near or over a radiator or other heat source.
•
The SIP-CS should not be placed outdoors (use indoors).
4 Installation Guide
CAUTION