Fujitsu Stylistic ST5000 Series Technical Reference Manual page 63

Command
&P 0 39% make/break ratio. 10PPS
1 33% make/break ratio. 10PPS
2 33% make/break ratio. 20PPS
&S 0 DSR always ON.
1 DSR comes on when establishing a connection and goes off when the
connection ends.
&T 0 Abort. Stops any test in progress.
1 Local analog loop.
&V View active configuration and stored profile.
&W Store current configuration
&Zn Store telephone number. (n=0, 1, 2, 3)
/A 0 Sets MNP block size max. 64 characters
1 Sets MNP block size max. 128 characters
2 Sets MNP block size max. 192 characters
3 Sets MNP block size max. 256 characters
/Bn Transmit break to remote. /B1-/B9 break length in 100ms units.
/K 1) Receives break from the DTE when on-line mode.
0, 2, 4
1
3
5
2) On-line command mode during a data connection. The /B is received in order to send
a break to the remote.
0, 1
2, 3
4, 5
3) Break is received from a remote modem during on-line mode.
0, 1
2, 3
4, 5
Specification
Enter on-line command mode, no break set to remote.
Clear data buffers and send break to remote modem
Send break to remote modem immediately.
Send break to remote modem in sequence with transmitted data.
Clear data buffers and send break to remote modem.
Send break to remote modem immediately.
Send break to remote modem in sequence with data.
Clears data buffers and sends break to the DTE.
Send a break immediately to the DTE.
Send a break in sequence with received data to the DTE.
AT Commands Table
Default
3
5
59