Configure Wpa-Personal (Psk) - D-Link DIR-615 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish wireless connectivity before
enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.
1.. Log into the web-based configuration by opening a web browser and
entering the IP address of the router (192.168.0.1). Click on.Setup.and
then click.Wireless.Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto, WPA2.Only, or.WPA.Only. Use Auto if
you have wireless clients using both WPA and WPA2.
4. Next to Cypher Type, select TKIP. and. AES, TKIP, or AES. If you have
wireless clients that use both types, use TKIP.and.AES.
5. Next to Group Key Update Interval, enter the amount of time before the
group key used for broadcast and multicast data is changed (3600 is
default).
6. Next to Pre-Shared Key, enter a key (passphrase). The key is entered as a
pass-phrase in ASCII format at both ends of the wireless connection. The
pass-phrase must be between 8-63 characters.
7. Click Save. Settings to save your settings. If you are configuring the
router with a wireless adapter, you will lose connectivity until you enable
WPA-PSK on your adapter and enter the same passphrase as you did on
the router.
D-Link DIR-615 User Manual

Configure WPA-Personal (PSK)

84