Adat Tab; Orpheus Drivers - Prism Sound Orpheus Operation Manual

Firewire audio interface

Hide thumbs Also See for Orpheus:

Table of Contents

Prism Sound Orpheus

Each input channel has a fader, a high-resolution

clipping, plus mute and solo buttons and a pan-pot. By engaging the 'Stereo' button beneath an input

pair, the pair is controlled by a single stereo fader, mute button and solo button, and the pan-pots are

replaced by a single balance control. The DAW contribution and output strip are always in stereo

mode.

Note that if the mixer tab is not active (because the output pair is in 'DAW' mode), the mixer controls

are still available but the output mode control in th output strip is highlighted in red.

For more information, see

6.1.5

ADAT tab

The ADAT tab contains eight high-resolution peak meters for the ADAT inputs and outputs. The

meter bank is assigned to the ADAT outputs by selecting 'Send' or to the ADAT inputs by selecting

'Return'

6.2

For Windows systems, Orpheus is supplied with a driver which provides ASIO and WDM connectivity

to the device. This driver is installed when the initial installation is performed. Thereafter, this

connectivity is permanently available. It is not necessary to run the Orpheus Control Panel applet for

applications to be able to use Orpheus; however, the applet is needed if any but the most basic

control of Orpheus' functions is required.

The same is true in Mac systems, except that no driver is installed because OS X is able to operate

Orpheus directly to obtain basic Core Audio functionality. However, whilst some degree of control is

possible from the Mac's Audio MIDI Setup, the Orpheus Control Panel applet must still be run to

control the majority of the unit's functions.

Operation Manual

Output mixers

in the hardware section.

peak

meter, with overload indication 0.05dB below

Revision 1.05

1.40

Table of Contents