Mixer Tabs - Prism Sound Orpheus Operation Manual

Firewire audio interface
Hide thumbs Also See for Orpheus:
Table of Contents

Advertisement

Prism Sound Orpheus
Operation Manual
Revision 1.05
Line output level is switched between +4dBu and -10dBV nominal by the '+4/-10' radio buttons.
The stereo digital output has a versatile
word-length
control using TPDF dither or Prism Sound SNS
(Super Noise Shaping), and the RCA connector can be switched to operate as either S/PDIF or AES3
as required. If the
sample rate converter
(SRC) is configured in the digital output, a separate sync
source and sample rate can be selected.
An
assignable level control
is available, for use as a stereo or surround monitor volume control, which
can be assigned to any desired outputs using the row of 'VOL' buttons. The volume control can be
adjusted using the mouse, as well as with the front-panel knob. There is also a mute button and a
numerical readout/setting box. Note that changes to the assignment of the level control can be
prevented by engaging the lock button (marked with a key symbol) just above the level control. When
engaged (red) the lock button prevents changes to the level control assignment in order to avoid
accidental full-level output.
Below each stereo output strip is a drop-list control allowing each output pair to be fed either directly
from the workstation ('DAW') or from a dedicated low-latency foldback mixer ('Mixer'). Each stereo
mixer can mix any of Orpheus' analogue or digital inputs to the output pair, along with the DAW feed,
as described in the following section. The headphone output pair has a third 'Bus' setting which
allows it to monitor any of the other output pairs using the row of headphone bus radio buttons.
All outputs have high-resolution
peak
metering, with overload indication 0.05dB below clipping.
6.1.4

Mixer tabs

The Mixer tabs control the low-latency foldback mixers which are available for each analogue output
pair, plus the stereo digital and headphone outputs. The mixers are enabled using the drop-list
controls on the
Output Setup
tab, which are duplicated in the output strip of each respective mixer.
© 2008 Prism Media Products Ltd
1.39

Advertisement

Table of Contents
loading

Table of Contents