Table of Contents
Advertisement
Prism Sound Orpheus
4
Installation procedures
This section contains detailed installation instructions for your Orpheus. If you are keen to get going
quickly, you could use the
4.1
Mac installation
The Orpheus Control Panel applet can be installed on Macs with either PowerPC or Intel processors.
You need a spare FireWire 400 (IEEE1394A) port. You must have OS X 10.4 Tiger, or 10.5 Leopard,
or later. No driver is required, since OS X can interface to Orpheus directly.
If you have Tiger, a patch must be installed before installing Orpheus - see the
the end of this section.
The full installation procedure is as follows:
· Connect your Orpheus to the mains supply with the power-cord provided. DO NOT connect it to
the Mac yet.
· Insert the installation disc into a DVD-ROM drive on your Mac.
· If 'Autorun' is not enabled, double-click on the DVD-ROM device
· Double-click on the "Install_Orpheus" package:
· A dialogue box will guide you through the installation process; click 'Continue':
© 2008 Prism Media Products Ltd
Operation Manual
Quick start guides
section.
Revision 1.05
instructions
at
1.12
Advertisement
Table of Contents
