Re-Torque Cylinder Head Inspection I (600 Mi. Only) - BMW R 1200 CL Service Manual

R 1200 CL
BMW Inspection I Procedures (600 Miles)
Re-torque cylinder head
Inspection I (600 Mi. only)
• Remove ignition coils using new special tool 12 3 561
• Remove cylinder head covers. C C a a u u t t i i o o n n : catch draining oil.
• Do not remove spark plugs.
• Set engine to OT (TDC) by turning the crankshaft with wrench or by placing
in 3rd gear and rotating the rear wheel.
• The OT will be visible in the inside window as shown
• Loosen one cylinder head nut at a time. Loosen nut further by hand and oil
threads with engine oil.
• Retighten to: 20 Nm (14 ft. lb.) - Additionally, angle torque: 180
• Re-torque the remaining 3 cylinder head nuts in a crosswise pattern in the
same manner.
• Loosen and re-torque the M10 bolt: 40 Nm (29 FT. LB.)
• Repeat on opposite side
R 1200 CL Introduction
O.
69