Final Preparation; Wiring Diagram - Viking 24” Use & Installation Instructions Manual

FINAL PREPARATION

1. Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior of the refrigerated
beverage center should be washed thoroughly with hot, soapy water, rinsed and wiped dry to remove film residue and any
installation dust or debris before being used. Solutions stronger than soap and water are rarely needed.
2. All stainless steel parts should be wiped with hot soapy water. If buildup occurs, do not use steel wool, abrasive cloths,
cleaners, or powders. If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to
loosen the material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape
stainless steel; scratches are almost impossible to remove.
UNDERCOUNTER 24" W. REFRIGERATED BEVERAGE CENTER

WIRING DIAGRAM

10
W W A A R R N N I I N N G G : : E E L L E E C C T T R R I I C C A A L L
G G R R O O U U N N D D I I N N G G
I I N N S S T T R R U U C C T T I I O O N N S S
This appliance is equipped with a
three prong grounding plug for
your protection against shock
hazard and should be plugged
directly into a properly grounded
three prong receptacle. Do not
cut or remove the grounding
prong from this plug.