THOMSON K2 Instruction Manual page 210

Chapter 6 Installing the Level 3R Storage System
L3 RAID
Chassis
Assign chassis address on Expansion chassis
Every chassis must have a chassis address. The Level three RAID chassis address is
fixed at 0, so no configuration is required. However, if you have any L3R RAID
Expansion chassis you must set their chassis addresses as shown in the following
illustration. One each Expansion Chassis, set the same address on both Expansion
adapters, regardless of whether or not the second Expansion adapter is connected to a
second RAID controller.
210 K2 Storage System Instruction Manual
Install L3 RAID Ethernet cabling as shown.
Expansion Chassis have no direct Ethernet connections.
Connect to a
control port
Ethernet Switch B
Ethernet cables
Connect to a
control port
A
Ethernet Switch
September 6, 2006