THOMSON K2 Instruction Manual page 101

snmp-server host public 192.168.40.11
19.Enable Authentication traps by typing the following:
snmp-server enable traps authentication
This allows NetCentral to test the switch to verify that it can send its SNMP trap
messages to NetCentral.
20.Type menu to get to menu mode. When prompted, save the configuration.
21.If you need a trunk for ISLs to gang switches together, use the following steps.
These steps illustrate trunking the last two ports for the two 10 Gig ISLs, which is
the recommended configuration for ISLs on all multi-switch K2 Storage Systems.
Refer to
with your Grass Valley representative if your requirements deviate from the
recommended policy:
a. At the main menu, select
b. Choose selection 2,
c. Press the right-arrow key to choose
d. Down arrow until at the bottom of the list of ports.
e. Right-arrow over to the Group column.
f. Use the Space bar and set the bottom port to
ISLs, this would be an ISL (Port 26).
g. Set the next port up also to
be the other ISL (Port 25).
h. Press
menu.
22.Return to the main menu.
23.From the main menu, tab to
prompt appears.
24.Type show flash to check the version of firmware currently installed on the
switch. Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image
-----
Primary Image
Secondary Image : 3287779
Boot Rom Version: I.08.07
Current Boot
25.Check the Primary Image Version and refer to K2 Storage System Release Notes
for information about currently supported versions and upgrade requirements.
Then proceed as follows:
• If you must upgrade the firmware on the switch, do so before continuing. Refer
September 6, 2006
"Design considerations for Ethernet switches" on page 376
Switch Configuration
Port/Trunk Settings
Trk1
, then right-arrow to
Enter
Command Line (CLI)
Size(Bytes)
----------
: 3287779
: Primary
Setting up the Level 2R redundant GigE switches
.
.
, then press
Edit Enter
. On a switch with the 10 Gig
Trk1
. On a switch with the 10 Gig ISLs, this would
. Press again and revert to previous
Save Enter
and press
Date Version
-------- -------
03/15/05 M.08.66
03/15/05 M.08.66
K2 Storage System Instruction Manual
and consult
.
. The command
Enter
101