THOMSON K2 Instruction Manual page 102

Chapter 4 Installing the Level 2R Storage System
26.Return to the main menu.
27.Choose
28.You can now use the switch's web browser interface for further configuration, as
29.Close the PC terminal program and disconnect the console cable.
30.Repeat this procedure on the other switch.
Continue with the next procedure
interface".
Configuring the GigE switch via the Web interface
For redundant systems with two switches, do the following on each switch.
The following steps are for the HP ProCurve switch, which is required for iSCSI
traffic. If you are using a different switch for non-iSCSI traffic, accomplish tasks
similarly on that switch.
1. From the control point PC or another PC, make sure that you have a direct Ethernet
2. On the PC, open Internet Explorer and type the switch's IP address in the Address
3. Press
NOTE: The configuration application for the HP ProCurve switch requires Java.
4. In the switch's configuration application, choose
102 K2 Storage System Instruction Manual
to the documentation you received with the switch. Then continue with the next
procedure "Configuring the GigE switch via the Web
• If the version is the currently supported version, continue with the next
procedure.
to restart the switch.
Reboot Switch
instructed in the next procedure.
cable connection to the switch, with no switches, routers, proxies, or other
networking devices in between.
field, as in the following example.
http://192.168.100.61
This should be the name or IP address as currently configured on the switch.
to open the switch's configuration application.
Enter
You can also access the switch's configuration application from the K2 System
Configuration application.
.
Configuration
"Configuring the GigE switch via the Web
Configuration
interface".
, then
Port
September 6, 2006