Ford 2006 Crown Victoria User Manual page 60

Driver Controls
• Continue to press and hold the
HomeLink button (note step 3
in the "Programming" section)
while you press and release —
every two seconds ("cycle")
your hand-held transmitter until
the frequency signal has been
accepted by the HomeLink . The
message CHANNEL "X" (1,2 or 3)
TRAINING will appear on the
display.
• Proceed with step 4 in the "Programming" section.
Operating the HomeLink Wireless Control System
To operate, simply press and release the appropriate HomeLink button.
Activation will now occur for the trained product (garage door, gate
operator, security system, entry door lock, or home or office lighting
etc.). For convenience, the hand-held transmitter of the device may also
be used at any time. In the event that there are still programming
difficulties, contact HomeLink at www.homelink.com or
1–800–355–3515.
Erasing HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be
erased):
• Press and hold the two outside
buttons. The message CLEARING
CHANNELS will appear on the
HomeLink display.
60