Norcold N109X Series Service Manual page 37

N109XIM (ice maker)
a. Reinstall the ice maker water valve.
b. Reconnect the ice maker water line.
c. Install the condenser retaining screws.
d. Connect the brown and the white wires to the water
valve solenoid terminals.
14. Install the spark/sense electrode assembly. Set
electrode-to-burner air gap 1/8 to 3/16 inch.
15. Install the burner box cover.
16. Connect the AC heater wires to power board
terminals AC_HT_LO and AC _HT _HI.
17. Reinstall the power board cover.
18. Connect the gas valve wires to the power board
terminals GV and GV_GND.
19. Plug the AC cord into the power board.
20. Connect the spark/sense electrode assembly to
the power board.
21. Attach the fan thermostat to the first condenser
fin from the left (as looking at the back), using the
screw holes provided.
Cut Thermal Mastic
sealant tube to dispense
a bead approximately
3/4 inch wide x 1/2 inch thick
figure 33. application of Mastic sealant on cooling unit (a) and cabinet step (b).
Refrigerator Service Manual
Apply a bead approximately
1/2 inch wide x 1/2 inch thick
(a)
(b)
N109X Models
37