Installing The Card Stacker - DataCard RP90 Plus E Hardware And Driver Installation Manual

Installing the Card Stacker

Card Stacker on Printer
Hang the stacker claw on the stacker receptacle as shown in the following figure. Be sure to
hang the card stacker claw on the card stacker receptacle, not on the card discharge slot.
The card stacker can hold up to 100 0.76mm (0.03 inch) thick cards or 280
0.25mm (0.01 inch) thick cards.
Card Stacker on Optional Laminator
When the optional RL90 laminator is installed, mount the card stacker claw on the laminator's
card stacker receptacle. Be sure to hang the card stacker claw on the card stacker receptacle,
not on the card discharge slot.
6 Installing the Printer