Providing Adequate Printer Ventilation; Connecting The Optional Rl90 Laminator - DataCard RP90 Plus E Hardware And Driver Installation Manual

•
Avoid unstable locations and angled surfaces.
•
Avoid locations prone to static electricity, such as a carpeted room.
•
Avoid areas near air conditioners, humidifiers, or heat sources that may
cause condensation within the printer.
The printer is to be installed in an environment with the following recommended temperature
and humidity range:
•
Temperature: 59°F. to 86°F. (15°C. to 30°C.)
•
Humidity: 35% to 70%
Caution: Using the printer in an environment with temperatures lower than
the recommended range may cause retransfer errors. Using the printer in an
environment with temperatures higher than the recommended range may
cause print errors including deformation of the cards and wrinkling of the film.

Providing Adequate Printer Ventilation

Ventilation holes are provided for the cooling fans on the bottom and sides of the unit. Install
the unit so the sides are at least 7.9 inches (200mm) away from the surrounding wall. Keep
the back of the unit at least 3.9 inches (100mm) away from a wall. Do not place any objects on
top of the unit.

Connecting the Optional RL90 Laminator

Make sure to install the units on a secure, level surface. Make sure the
laminator and the printer fit securely into the joining plate holes.
Caution: Make sure that the power switch is turned OFF and the power
cable is detached from the receptacle before connecting or disconnecting the
laminator. If not, electric shock, fire, or malfunction of the product might
occur.
RP90 Plus Card Printer Installation Manual 3