Restoring Programming Defaults; Restore Defaults - Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Installer Testing

Restoring Programming Defaults

To soft reset the Control Panel back to the factory defaults, use the
Restore Default option in the Installer toolbox.
✓ NOTE: The Control Panel may also be "hard" reset to
out-of-the-box factory defaults by pressing and holding the
emergency and home buttons while applying power (if not
disabled through programming questions Q-44 & Q-45).

Restore Defaults

The Restore Defaults screen provides a method to selectively reset the Control
Panel to its default programming values instead of using a full "hard" reset.
Two check box options are available; one or both must be checked:
• If the ZONES box is checked, all data for the 48 sensors will be erased and
replaced with the default values.
• If the CONSOLE box is checked, all the Control Panel programming questions
will be erased and replaced with the default values. The User Codes will be
erased, the backlight timeout is reset to fi ve minutes, and the brightness/
volume settings are reset.
42
Figure 74. Restore Defaults Screen