Installer Testing; Testing The System; Sounder Disable/Enable; Zone Reporting Test - Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Go!control 2gig-cntrl2 wireless security system

Hide thumbs Also See for 2GIG-CNTRL2:

User manual (52 pages)

Operation & user’s manual (24 pages)

Operation & user’s manual (28 pages)

Table Of Contents

Table of Contents

Testing the System

After the installation is complete and the Control Panel

programming is complete, the system must be tested to ensure

proper operation.

System testing is performed through the Installer Toolbox screen.

1. From the Home Screen, press SECURITY, MENU,

then TOOLBOX to access the Toolbox Screen.

2. Press the → arrow to go to the Toolbox Screen

2 of 3, then press INSTALLER TOOLBOX.

3. Enter the Installer Code (default = 1561) to access the Installer Toolbox.

Sounder Disable/Enable

Since installer testing will cause the Control Panel's internal and

external alarm sounder to activate, an option to lower the sounder

is available.

1. From the Installer Toolbox Screen, press DISABLE SOUNDER.

2. A conﬁ rmation screen will be displayed. Press OK. Four beeps

will sound from the internal sounder, and a short siren will sound

from the external sounder. The external siren will be disabled

and the internal sounder will be lowered for 30 minutes.

3. A second conﬁ rmation screen will be displayed to verify

that the test sounds were produced. Press OK.

4. While the sounder is disabled, the sounder disable

icon will be displayed on the status bar.

The sounder disable will automatically time out after 30 minutes,

and the sounder will automatically become active again.

To re-enable the sounder manually, follow these steps:

1. From the Installer Toolbox Screen, press ENABLE SOUNDER.

2. A conﬁ rmation screen will be displayed. Press OK.

Zone Reporting Test

To verify that the Central Station will correctly receive reports from

each zone type, perform the following tests:

1. Inform the Central Station that test signals will be sent.

2. Trigger a 24-hour ﬁ re sensor (if installed) or press the FIRE

emergency button (if enabled), wait about 45 seconds for

the report to complete, then disarm the Console.

3. Trigger a 24-hour panic sensor (if installed) or press the

PANIC emergency button (if enabled), wait about 45 seconds

for the report to complete, then disarm the Console.

4. Trigger a 24-hour emergency sensor (if installed) or press the

EMERGENCY emergency button (if enabled), wait about 45

seconds for the report to complete, then disarm the Console.

5. Arm the system then trigger a burglary sensor, wait for

the system to go into alarm, wait about 45 seconds for

the report to complete then disarm the Console.

6. Check with the Central Station that each zone type was reported,

then inform the Central Station that the testing is complete.