Table of Contents
Advertisement
Before use
AG-MX70 connections
It is necessary to connect the PC to the AG-MX70 using the
USB cable before installing the software. Follow the steps
below.
1) Turn off the power to the AG-MX70.
2) Connect the PC to the AG-MX70 using the USB
cable.
Insert
the
USB
cable
corresponding USB ports on the PC and on the rear
panel of the AG-MX70.
This completes the connection. When the 2 units are being
connected for the first time, install the USB driver by
following the steps in "Installation of USB driver" below.
<Note>
The USB cable is not supplied with this unit.
commercially available 3 m or shorter USB cable. Note that
if the cable to be used is more than 3 m in length,
communications may not be performed correctly.
Installation of the USB driver
It is necessary to install this driver in the PC to enable USB
communications between the PC and AG-MX70 after they
are connected for the first time. (It is only necessary to
install the USB driver software once.) Follow the steps
below.
∫ For Windows 98 and Windows 2000
<Notes>
≥ The steps outlined below are for Windows 98. With
Windows 2000, the screens will differ slightly, but the
driver software can still be installed following the same
steps.
≥ Be sure to log on as a user with Administrator rights when
installing this software in a PC with Windows 2000.
1) Connect the PC to the AG-MX70 correctly.
2) Turn on the power to the PC.
Check that Windows has started up.
3) Place the setup CD-ROM in the PC's CD-ROM drive.
4) Turn on the power to the AG-MX70.
After a short while, the "Add New Hardware Wizard"
dialog will be displayed.
5) Click on the "Next" button.
connectors
into
the
Use a
78 (E)
6) Select "Search for the best driver for your device,"
then click on the "Next" button.
7) Place a check next to "Specify a location," enter the
USB_DRV folder in the setup CD-ROM as the search
location and click on the "Next" button.
8) If the driver is searched correctly, a screen similar to
the one shown below will be displayed.
9) When the screen indicating that the installation is
complete is displayed, click on the "Finish" button.
Hide quick links:
Advertisement
Table of Contents
