INSTALLING CANOPY
A canopy is furnished with each firebox and MUST be installed for safe operation. See Figure 14.
1. Remove the three (3) screws from the top front frame assembly. Also remove the two (2) screws on the side
frames. See Figure 15.
2. Align the canopy with the holes in the top frame.
3. Replace the screws previously removed.
4. Tighten side screws. Make sure the canopy is level and
secure.
Close fireplace screen panel before
operating a decorative type unvented
room heater.
INSTALLING RADIANT FACE PLATES
1. Remove the two radiant face plates from the uprights on
the top of the firebox. Remove packing foam.
2. Snap off the three upper louvers and the three lower
louvers as shown in Figure 16.
3. Snap on the upper radiant face plate and the lower radiant
face plate as shown in Figure 16.
26D3312
CANOPY AND RADIANT FACE PLATES INSTALLATION
The firebox canopy must not be
modified or replaced with a canopy
that may be provided with the unvented
decorative room heater.
Figure 15 - Installing Canopy
Louvers
Radiant
Face Plate
Louvers
Radiant
Face Plate
Figure 16 - Installing Radiant Face Plates
13