Product Features; Before You Start - Monessen Hearth GCUF32 Installation And Operating Instructions Manual

Unvented vent-free fireboxes

Hide thumbs Also See for GCUF32:

Brochure & specs (6 pages)

Table Of Contents

Table of Contents

Do not attempt to burn solid wood fuels, vented gas log sets, or any other combustible

in this unvented firebox. Also, do not install a vent-free gas log set in this firebox

if the minimum clearance and height requirements of the log set are too large

for the firebox.

The GCUF32, GCUF36 and GCUF42 Series are vent-free fireboxes. They feature a self contained heat-circulating system.

These units also feature a 2-in1, flexible-face system that converts the circulating system into a radiant system in seconds.

This installation manual will enable you to obtain a safe, efficient and dependable installation of your vent-free

fireplace system.

Do not alter or modify the firebox or its components under any circumstances. Any modification or alteration of the firebox

system, including but not limited to the firebox and accessories, may void the warranty, listings and approvals of this system

and could result in an unsafe and potentially dangerous installation.

BEFORE YOU START

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the

dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have

all the parts in good condition.

MAKE SURE YOU HAVE RECEIVED ALL PARTS

Check your packing list to verify that all listed parts have been received. You should have the following:

1. Vent-Free Gas Firebox

2. Canopy

3. Installation and Operating Instructions

WHAT YOU WILL NEED FOR INSTALLATION

TOOLS

• Phillips screwdriver

• Hammer

• Saw and / or sabersaw

• Level

• Measuring tape

• Electric drill and bits

Refer to the installation instructions provided with the log sets for items required for log set installation.

Illustrations shown in this manual reflect "typical" installations with nominal

dimensions and are for design and framing reference only. Actual installations

may vary due to individual design preferences. However, always maintain minimum

clearances to combustible materials and do not violate any specific installation

requirements.

26D3312

4. Five (5) sheet metal screws for canopy

5. Two (2) nuts and bolts for grate

6. Two (2) radiant face plates

• Square

• Piping complying with local codes

• Tee joint

• Pipe wrench

• Pliers

• Pipe sealant approved for use with propane/L.P.G. (resistant to sulfur compounds)