Advertisement
Q-D5 MKII™
Top Panel
6a
6b
5
4
3
2
1
1. OPtICaL CrOssFaDer - This fader is used to blend the output signals of channels one and two
together. When the fader is in the full left position (channel 1), the output signal of channel one will be
controlled by the master volume level. The same fundamentals will apply for channel two. Sliding the
fader from one position to another will vary the output signals of channels one and two respectively.
When the crossfader is set in the center position, the output signals of both the channels one and
channels two will be even.
2. ChanneL FaDer - These faders are used to control the output signal of any source assigned to
its particular channel.
3. ChanneL transFOrMer sWItCh (rePLaCeabLe anD aDjUstabLe) - These switches
are used to select the input source assigned to each channel. Each channel may only be assigned one
input source at a time. The TRANSFORMER SWITCH may be used in an up/down or left/right pattern.
To adjust the transformer orientation please follow the instructions on page 13.
4. PFL bUttOns - These buttons are used to activate a channels "CUE" mode. A red LED next
to the PFL button will glow when a channels cue mode is activated. Cue mode will send a channels
incoming signal to the headphones. The cue level is adjusted by the CuE LEvEL AdjuSTMENT KNOb
7
American Audio
- www.AmericanAudio.us - Q-D5 MKII™ Instruction Manual Page 5
©
®
8
9
Controls and Features
10
11
12
13
14
15
16
Advertisement
