Remote Control Button - Panasonic CS-E7HKEW Service Manual

• During Remote Control Number Switch Mode, press any button at remote control to transmit and store the transmission code to
the EEPROM.

14.3. Remote Control Button

14.3.1. SET BUTTON
• To check current remote control transmission code
- Press for more than 10 seconds.
• To change the air quality sensor sensitivity
- Press and release with pointer.
- Press the Timer Decrement button to select sensitivity:
1. Low Sensitivity
2. Standard (Default)
3. Hi Sensitivity
- Confirm setting by pressing Timer Set button, a "Beep" sound will be heard. LCD returns to original display after 2 seconds.
- LCD returns to original display if remote control does not operate for 30 seconds.
14.3.2. CLOCK BUTTON
• To change the remote control's time format
- Press for more than 5 seconds.
14.3.3. RESET (RC)
• To clear and restore the remote control setting to factory default
- Press once to clear the memory.
14.3.4. RESET (AC)
• To restore the unit's setting to factory default
- Press once to restore the unit's setting.
14.3.5. TIMER
• To change indoor unit indicator's LED intensity
- Press continuously for 5 seconds.
14.3.6. TIMER
• To change remote control display from Degree Celsius ( C) to Degree Fahrenheit ( F).
- Press continuously for 10 seconds.
Remote Control Printed Circuit Board
Jumper A (J-A)
Short
Open
Short
Open
60
Jumper B (J-B) Remote Control No.
Open A (Default)
Open B
Short C
Short D