Spectralink 8400 Handset Configuration; Spectralink 8400 Phone Settings - Phone User Interface - ShoreTel Spectralink 8400 User Manual

StripVideoCodec=1
AddGracePeriod=0
FakeDeclineAsRedirect=1
XferFailureNotSupported=1
Save the changes.
Note: Please do not disable any of the default SIP profiles. In case there are issues with the custom profile
defined, disabling the system profiles may cause the Spectralink
system. Refer to ShoreTel's Planning and Installation Guide for more information.

Spectralink 8400 Handset Configuration

To setup the Spectralink 8400 handsets with the ShoreTel system, it must first be installed and operating on the
network, please refer to the respective Spectralink 8400 Series Wireless Telephone Deployment Guide or UC
Software Administrator's Guide at:
http://support.spectralink.com/SpectralinkService/support/us/support/voice/wi-
fi/spectralink_8400_wireless.html
Note:
Spectralink strongly recommends using configuration files hosted by a centralized server for all
Spectralink 8400 Series Handset configuration and settings. Please see Spectralink's setup & maintenance
documents on configuration file management in the troubleshooting section at the end of this document. If a
centralized server is unavailable, you may configure the devices by hand as directed below.
To configure the Spectralink 8400 handsets we used a DHCP server for the network parameters, and then
manually provisioned the minimum configuration parameters required for validation with the ShoreTel system.
Spectralink 8400 Phone Settings – Phone User Interface
The following settings will be managed through the phone's menu interface:
1. From the Home screen, navigate to Settings, then Advanced Settings.
2. At the Enter Password prompt, enter the administrative password (The default password is 456).
3. Select Administration Settings, then Line Configuration.
4. Set the Calls Per Line Key parameter as desired.
5. Navigate to the parameter Line 1and press the OK key.
6. Enter the desired Display Name. Use the Mode softkey to toggle between text and numbers.
7. Navigate to the parameter Address and enter the desired address (example: 392 Our example is set as
the extension number associated for this user created in ShoreWare Director). Use the Mode softkey to
toggle between text and numbers.
8. Navigate to the parameter Label and enter the desired label (example: 392) as you would like it to be
displayed on the Spectralink 8400 handset. Use the Mode softkey to toggle between text and numbers.
8400 handsets to not be added to the ShoreTel