Table of Contents
Advertisement
7.2 MCU Does Not Function Normally
The program operates normally on the emulator, but when the MCU that has normally been written
is attached the same program does not function normally.
(1) Is the offset address specified correctly when copying data into the PROM programmer?
(2) In the emulator, NOPs are often inserted in the area where the program has not been read, therefore
the program happens to appear functioning normally even though it may have gone wild. Check
your program again.
(3) The emulator and the actual MCU may differ in characteristics. Consult the user's manual of the
emulation pod to check for differences in characteristics again.
7.3 Other Precautions
7.3.1 About the Recommended PROM Programmers
Not all PROM programmers available on the market can be checked to see if they function properly.
There are several PROM programmers that we have verified to function properly. These products are
listed as recommended PROM programmers in "5. Recommended PROM Programmers". Other
PROM programmers may also be used providing that you verified them to function properly.
Note: No matter which type of PROM programmer you use, it is necessary to verify completion of
7.3.2 About Reading Out of Device Identification Code *
Please do not use the PROM programmer's device identification code readout function.
Using this function may break down the MCU. The device identification code is included in EPROM
to indicate the manufacturer code and device code; it is not included in the MCU.
1
*
Depending on PROM programmer manufacturers, this may be referred to by another name (e.g.
ID code).
programming by executing screening, etc. that are stipulated for each MCU used.
( 14 / 14 )
1
Advertisement
Table of Contents
