Table of Contents
Advertisement
ii
Read First Before Installing Your zBoost Product
Before unpacking this box, verify that your phone operates on the frequency
band supported by this product.
-
-
-
(NOTE) The YX500 Series is not compatible with iDEN, Nextel, SMR or ESMR
To verify that your phone will work in conjunction with the model
purchased, please follow these four simple steps:
1)
Unpack the Base Unit, Base Unit Antenna and power supply only.
2)
Connect the Base Unit Antenna and the power supply to Base Unit and plug
it into an outlet. The green power light will illuminate.
3)
Bring the unit to an area where there is enough signal to place a call (using
an extension cord may be necessary). If the Signal light begins flashing
green while placing a call, you can proceed with the installation of the
system. If it flashes red, move your phone further away from the Base
Unit (typical for GSM) and retry.
4)
If the Signal light does not flash green, try to place another call with your cell
phone directly touching the unit. If the Signal Light still does not flash
green, your cell phone may be operating on frequency supported by a
different model. Some carriers, such as Cingular and Verizon change
frequency depending upon location. Go to
contact Wi-Ex technical support at 1-800-871-1612 for further
assistance.
wpsantennas.com
Wi-Ex
zBoost YX500/510 Series Installation Guide
The YX500-CEL will enhance your in-building coverage for local
provider networks operating at the 800MHz (Cellular) frequency.
The YX500-PCS will enhance your in-building coverage for local
provider networks operating at the 1900MHz (PCS) frequency.
The YX510-PCS-CEL will work for both Cellular and PCS
frequencies.
frequency services.
www.wirelessadvisor.com
or
(877) 594-5766
Advertisement
Table of Contents
