Table of Contents
Advertisement
wpsantennas.com
zBoost YX500/510 Series Installation Guide
4)
Attach the power supply to the Base Unit and plug the power supply into
an outlet. See the Troubleshooting section if a Red light is lit
Wall Mounting the Base Unit
The Base Unit can also be easily mounted on a wall using the
included mounting bracket hardware. The Base Unit should be a
minimum distance of 4-5 feet off from the floor so there is clearance
for the Base Unit antenna extension.
Perform the following steps to mount the Base Unit on a wall:
1)
Remove the mounting bracket from the Base Unit by slightly
spreading the tabs on the gray mounting bracket.
2)
Fasten the mounting bracket to the wall using the self-tapping
wall/ceiling anchors
3)
Attach the coaxial cable from the Signal Antenna to the Base
Unit.
4)
Attach the antenna to the Base Unit.
5)
Attach the power supply to the Base Unit and plug the power
supply into an outlet. See the Troubleshooting section if a Red
light illuminates.
6)
Snap the Base Unit into the mounting bracket.
Confirm That Your zBoost is Working Properly
Perform the following steps to confirm that the unit is now working properly:
1)
Unplug the Base Unit power cord.
2)
Turn on your cell phone and check the signal meter.
3)
Plug the power cord into the Base Unit.
4)
Hold your cell phone about 5 feet from the Base Unit and then turn it on.
Wait up to 1 minute for the cell phone to register the signal coming from
the Base Unit.
5)
If the signal meter shows an improvement, your zBoost unit is working
properly.
Note:
The Signal light may flash green indicating that a
call is in progress and zBoost is boosting your
signal. In some cases, it may only flash at the
beginning of the call. If the Signal light displays
either a solid or flashing red move your phone
away from the Base Unit and see the
troubleshooting section.
Wi-Ex
.
(877) 594-5766
13
Advertisement
Table of Contents
