Table of Contents
Advertisement
Instructions for Installation (cont'd)
9. Slide the 6" telescoping vent section apart to reveal the
12. Install the vent collar assembly through the wall, connect-
beads,
ing it to the 6" telescoping extension. Remember, the
extension is not connected yet and it may be necessary to
NOTE: The section of 6" pipe with beads will connect
go back indoors and push it back up for a tight fit to the
to the elbow. Using the caulking supplied, fill the beads,
coUar.
10. Insert the 6" telescoping vent section into the wall.
I3. We have supplied 4 wood screws to temporarily attach the
I1'
II
II _. [I
[L
_[&
collar to the exterior wall to the building. However, other
.....
_
types of screws may have to be substituted depending on
I
II
11. Move outdoors with all the remaining vent parts. Using
¢'<__,-r - J
the robe of sealant supplied, run an ample amount on the
.....
inside surface of the collar assembly that will contact the
exterior wall and also fall the bead on the end o£the 6"
14. Place the vent cap in the vent collar assembly.
diameter vent collar.
23
Advertisement
Table of Contents
