Cabling The System; Typical System - AJA io XT Installation And Operation Manual

Cabling the System

Typical System

Io XT Installation and Operation Manual — Cabling the System
Your system may differ depending on VTRs, audio monitoring, and video
monitoring.
1. If desired, connect your house reference sync to the Io XT Ref/LTC
connector (BNC). The second Io XT Ref Loop connector (if used in Pass
through mode) can be connected to the VTR or terminated with a 75-ohm
terminator. If instead using LTC timecode input, connect to the Ref/LTC
input.
2. Connect an HDMI Video Monitor to the Io XT HDMI Out connector. Or
instead, use the Component Analog Video Out BNC connectors to go to an
analog monitor.
3. Connect a 9-pin DE-9 machine control cable between your VTR's RS422
control port and the Io XT RS-422 machine control connector.
4. Connect two SDI cables between Io XT and your digital VTR (Digital
Betacam etc.): one from Io XT SDI In to the VTR SDI Out, and one from Io XT
SDI Out to the VTR SDI In. The Io XT SDI connections have embedded audio
so the VTR must be configured accordingly.
5. Use a Tascam-style audio breakout cable to connect stereo output for
audio monitoring.
13
1