Mercedes-Benz E 300 Operator's Manual page 79

Garage Door Opener
1 Remote control transmitter
located on inside rear view
mirror
2 Portable remote control
transmitter
Warning!
When programming a garage door
opener, the door moves up or down.
When programming or operating the
remote control make sure there is no
possibility of anyone being harmed
by the moving door.
The visor remote control is capable of
operating up to three separately
controlled objects.
Notes:
Certain types of garage door openers are
incompatible with the integrated opener.
If you should experience difficulties with
programming the transmitter, contact
your authorized Mercedes-Benz dealer
or call Mercedes-Benz Customer
Assistance Center (in the U.S.A. only) at
1-800-FOR-MERCedes.
For operation in the USA only: This
devise complies with Part 15 of the FCC
Rules. Operation is subject to the
following two conditions:
(1) This device may not cause
harmful interference, and
(2)
(3) this device must accept any
interference received, including
interference that may cause
undesired operation.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
Programming or reprogramming the
remote control:
1. Turn electronic key in steering
lock to position 1 or 2.
2. Press and hold one button of
the remote control located on
the inside rear view mirror until
its control light begins to flash at
a rate of about once a second.
Continue holding down the
button.
Note:
The light blinks immediately if the
remote control is being
programmed for the first time, or if
its memory was previously erased.
If you are reprogramming a
previously used button, the light
will flash after about 20 seconds.
3. Hold end opposite to battery of
portable remote control against
the inside rear view mirror trans-
mitter to be programmed. While
still holding down the button on
the transmitter on the inside rear
view mirror, press down the
button on your portable remote
79