Mercedes-Benz E 300 Operator's Manual page 64

Combination Switch
1 Low beam (exterior lamp
switch position )
2 High beam (exterior lamp
switch position )
3 High beam flasher (high beam
available independent of
exterior lamp switch position)
4 Turn signals, right
5 Turn signals, left
To signal minor directional changes,
such as changing lanes on a highway,
move combination switch to the point
of resistance only and hold it there.
To operate the turn signals
continuously, move the combination
switch past the point of resistance (up
or down). The switch is automatically
canceled when the steering wheel is
turned to a large enough degree.
6 Control for windshield
wiper/washer system:
Push briefly for single wipe
without adding washer fluid (use
only when windshield is wet)
Push past detent and hold
to activate wiper and washer
7 Windshield wiper
0 Wiper off
I Intermittent wiping
(optional rain sensor:
One initial wipe, pauses between
wipes are automatically
controlled by a rain sensor
monitoring the wetness of the
windshield.)
II Normal wiper speed
III Fast wiper speed
Note:
The windshield washer reservoir, hoses
and nozzles are automatically heated.
Turn Signal Failure
If one of the turn signals fails, the turn
signal indicator system flashes and
sounds at a faster than normal rate.
64