American DJ Spherion Tri LED User Instructions page 9

Spherion Tri LED
BLND -
Blackout or Stand by mode.
1. Press the MENU button until "BLND" is displayed, press
ENTER. Either Yes or No will be displayed.
2. To activate Blackout tap the UP or DOWN buttons until "Yes"
is displayed, press ENTER to confim. The fixture will now be in
Blackout mode. To deactivate Blackout mode, select "No" and
press Enter.
LED -
With this function you can have the LED display turn
off after 10 seconds.
1. Press the MENU button until "LED" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display on at
all times, or "OFF" to switch to have the LED display switch off
after 10 seconds.
3. Press ENTER to confirm.
DISP
- This will "flip" the LED display 180º.
1. Press the MENU button until "dISP" is displayed, press
ENTER.
2. Either "dISP" or "dSIP" will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. Press the ENTER, and then press and hold the MENU button
for at least 3 seconds to confirm.
TEST
- This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, press
ENTER.
American DJ - www.americandj.com - Spherion Tri LED Instruction Manual Page 12
© ®
System Menu Spherion Tri LED
Operating Modes: The Spherion Tri LED can operate in four
different modes. In each mode you can run the fixture as a
stand alone fixture or in a master/slave confiugration. This next
section will detail the differences in the operating modes.
• Sound Active mode -
The fixture will react to sound.
• Show mode -
Choose 1 of 7 show modes to run.
• Program mode -
Choose 1 of 7 show modes to run.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation
Designer.
System Menu: When making adjustments you can press
ENTER to confirm your setup or you can wait 8 seconds for
automatic setup. To exit without making any adjustments
press the MENU button.
ADDR -
mation on DMX Control.
1. Press the either the MENU, UP, or DOWN buttons until
"ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
Press ENTER to set your desired DMX address.
CHND -
1. Press the either the MENU button until "CHND" is displayed,
press ENTER. Either "1CH" or "3CH" will be displayed
2. Press the UP or DOWN buttons to choose your desired DMX
mode and press ENTER to confim and exit.
©
™
DMX Address Setting. See page 14 for more infor-
This will let select your desired DMX mode.
American DJ - www.americandj.com - Spherion Tri LED Instruction Manual Page 9
®
System Menu
Show
®