Cautions & Safety Information - Suburban DD-17DSI Service Manual

1. Never use a battery charger to power or test an electronic ignition furnace as they som etim es provide m ore than
14.5 DC Volts that could dam age the m odule board.
2. Never operate the furnace with the electrode wire disconnected nor with the electrode assem bly rem oved
from the furnace.
3. Never use a screwdriver on any part of the electrode assem bly while the furnace is in operation.
4. Be certain that the spark from the electrode never reaches the flam e sensor portion of the electrode assem bly
on rem ote sense units.
5. Install the furnace so electrical com ponents and connections are protected from water.
6. W ire the furnace direct to the battery when possible.
7. Use two wrenches on gas fittings when tightening gas connections.
8. Verify voltage of furnace, do not use 120 volt AC with 12 volt DC.
9. Do not m odify the furnace in any way.
10. Do not vent the furnace to an outside enclosed porch area or where the vent is covered or obstructed.
11. Always m eet or exceed m inim um duct requirem ents. Also m eet the m inim um return air requirem ents.
12. Furnace m ust be installed and vented correctly. Refer to the Installation Manual for the specific m odel furnace.
13. Do not install afterm arket com ponents.
CAUTIONS & SAFETY INFORMATION
SUBURBAN MANUFACTURING COMPANY
676 Broadway Street
Dayton, Tennessee 37321
423-775-2131
Fax: 423-775-7015
www.rvcomfort.com
E-mail: info1@suburbanmfg.com
2007