Table of Contents
Advertisement
Troubleshooting
Symptom/Situation
Power indicator (charger) is not
lit/displayed. (All stations)
Power indicator (charger) is not
lit/displayed. (Single Station/
Fault)
Battery Rejected indicator is dis-
played. (Amber flashing)
Station goes to ready in a short
period of time (5-15 minutes).
Station will not go into Charge
mode. (Amber solid indicator)
Station will not go into
Condition mode. (Amber solid
indicator)
(NiMH only)
(Li-Ion does not condition)
Battery becomes hot
Power supply shuts down
temporarily.
Probable Cause
AC power supply cord not con-
nected to wall outlet.
Power supply cord not
connected to battery charger.
Bad power supply.
Bad fuse.
Bad docking station, charger.
Faulty LED.
Faulty condition identified.
Over discharge of battery.
Defective Battery.
Battery is fully charged.
Faulty battery.
New Battery.
Charger not seated correctly.
Bad charger.
Defective battery.
Faulty LED.
Battery too hot.
Battery not designed to
condition in the charger.
Faulty LED.
Defective battery.
Power line surge.
Corrective Action
Check power supply
connections.
Replace power supply.
Replace fuse.
Do not use station.
Return for repair.
Try another charger.
Remove battery from
charger and reinsert.
Re-seat docking station.
Allow to sit in charger for
15 minutes, then reinsert.
Replace battery.
Try conditioning battery.
Replace battery.
Remove battery from charger
and reinsert.
Re-seat charger.
Replace charger.
Replace battery.
Send in for repair.
Remove battery.
Do not condition.
Send in for repair.
Immediately remove battery
from charger and replace.
Power will automatically reset.
www.huskietools.com • Huskie Tools
11
Advertisement
Table of Contents
