Table of Contents
Advertisement
Installation
MCA-DVBT-TV-01 is designed to replace your old, analog TV Tuner.
Therefore, it makes use of existing setup which is assumed to have
been put in place when you had your analog tuner installed. If this is
not your case and this is your first TV tuner, installation will take
additional steps for which external documentation should be available
from your car manufacturer.
Installation overview
If you already have an installed TV tuner (an old analogue TV tuner
•
for example), installing MCA-DVBT-TV-01 is a simple plug and play
procedure.
If this if the first TV module for your car, installation is similar to
•
retrofitting an original TV tuner. We recommend you to follow the
steps in the BMW retrofit documentation for your particular car
model.
Replacing existing TV module with MCA-DVBT-TV-01
Wait for navigation to shut down (for led to turn off). Depending on
•
your car equipment, it should take around 1-5 min
Disconnect the negative terminal of the car battery
•
Remove the old TV module and put the MCA-DVBT-TV-01 in its
•
place
Connect the white and blue car cable connectors to corresponding
•
connectors on MCA-DVBT-TV-01 panel
Connect car antennae to corresponding connectors on MCA-DVBT-
•
TV-01 panel
If you wish to control the TV tuner via remote control, connect
•
supplied IR cable to IR connector on MCA-DVBT-TV-01 and route IR
cable so that the receiver ends up in a location that is most
6
Advertisement
Table of Contents
